نوع مقاله : پژوهشی
نویسندگان
1 دانشکده ی مهندسی عمران، دانشگاه اصفهان
2 دانشکده ی مهندسی عمران، دانشگاه صنعتی اصفهان
3 مرکز تحقیقات راه، مسکن و شهرسازی
4 دانشکده ی مهندسی عمران، دانشگاه تهران
چکیده
کلیدواژهها
عنوان مقاله [English]
نویسندگان [English]
A wide variety of systems have been introduced so far for the construction of
roofs, as one of the most essential structural components of buildings. A
conventional roofing system is the solid slab that offers adequate rigidity to
distribute gravitational and seismic loads, while it is also relatively resistant against fire. However, its main drawback is its overweight that increases the associated seismic loads. To resolve this problem, modifications were proposed that resulted in different types of biaxial voided slabs. In one such system, spherical and ellipsoidal plastic balls enclosed in steel cages were used to eliminate ineffective concrete. Due to the novelty of the system, however, little was known about the bending behavior of the roof thus constructed. Most of previous studies have been conducted on spherically-shaped voids ignoring ellipsoidal ones. This is while the effect of supporting cages on voids has not been investigated at all. The present study was, therefore, designed and implemented to study the behavior of biaxial voided slabs containing ellipsoidal plastic balls and the effect of supporting cages on bending behavior. To investigate these aspects of the system, two full-scale
bending specimens were cast for investigating bending capacity, cracking
distribution, and deflection in solid and biaxial voided slabs. Moreover, the
effect of cage longitudinal rods was studied on the ultimate capacity of the
bending specimens. Finally, the experimental results were then examined by ACI
318-14 recommendations to put forth suggestions for using the ACI 318-14
equations in designing biaxial voided slabs. It was found that while both solid
and biaxial voided specimens exhibited almost similar bending behavior and the
same failure mode. Also, the bending behavior of biaxial voided specimen was
affected by the steel cages used. So, to use the ACI 318-14 equations, if this
longitudinal cage bar is considered, the percentage difference between
experimental and calculated results reached just one percent.
کلیدواژهها [English]
)